Automotive Engine Fault Diagnostic Trouble Training Simulator

YESA-3102PA

Product Name: Automotive Engine Fault Diagnostic Trouble Training Simulator
Model Name: YESA-3102PA

Feature

■Engine Simulator Equipment which equipped with fuel, cooling, ni take, exhaust and car electricity system so that allows varieyt of theoretical
training and experiments.
■The purpose of this equipment is to use PC and fault insertion software or optional Fault insertion modules to insert faults into the equipment and
to improve the trainees' ability to understand fault signals and to diagnose and resolve faults.
■Pressure gauge is attached on each range of hydraulic line onA /T for circuit training of each shifting process.
■Check terminal box is attached for the test of electronic circuits and sensors with diagnose devise.
■Ability to use with OBD socket.
■Experimental and training guide manual for the whole system including diagnostic and fault detection.

Specification

■ Composition
1) GDI system, 4 cylinder 4 stroke engine_Hyundai AVANTE AD _ G1.6 GDI, Auto Fault
2) Combined ignition & electronic injection with ECU
3) Starter, Alternator, Battery
4) Automatic Transmission Assembly with ECU
5) Electrical and electronic devices
6) Injector, Fuel Filter, Fuel Tank, Fuel Pump, Fuel Equipment, DC 12V/60A Battery for Vehicles, Generator
7) Ignition coil, Spark Plug, High Voltage Cables etc
8) Cooling System such as Radiator, Overflow Tank, Relay, Electric Fan
9) Exhaust System such as Catalytic Converter, Emission, Silencer
10) Ignition Switch (Key S/W) Anti-vibration dampers and a urethane wheels
11) Control box, fuel tank (removable), accelerator lever
12) Stainless molding type safety guard is installed
13) Radiator-only stand and laser processing protection panel
14) Automatic transmission oil pressure gauge 6 units
15) Vacuum pressure gauge 1 unit
16) Fuel pressure gauge 1 unit
17) Battery voltage gauge 1 unit
18)Fault insertion, control panel open and close feature and 3 stage PCB board mounted
■ Size : Approx. 1,200 X 1,300 X 1,400 mm
■ Weight : Approx. 400 kg

Training Contents

■Various practices by self-diagnosis used Diagnostic car scanner.
■Various practices by Electric-controlled gasoline engine tune-up.
■Measurement and inspection of Auto transmission.
■Measurement of exhaust, inspection of compression pressure of cylinder.
■Measurement of radiator cap pressure and inspection of the leakage from the radiator.
■Operation test of Fuel pump, Measurement and inspection of Oil pressure.
■Measurement and adjustment of tensions of timing chain and fan belt.
■Measurement and adjustment of voltage and current in such as a charging circuits, start circuits.
■Connector checking terminal for inspection of sensors and actuator. Inspection of every part of each automotive electricity, fuel system, ECU, sensors and actuator.
■Inspection of belts in cooling system and pumps.
■Names of main components of GDI Engine with Auto Transmission Training System can be understood.
■Correct equipment operating method can be understood and operated.
■Measure the waveform of Crank position sensor or voltage values by 4 channels automotive oscilloscope.
■Analysis of the waveform from the injector
■Measure the waveform of Accelerator Position Sensor, Rail pressure sensor, Crank shaft position sensor
■Measure the waveform of Cam shaft position sensor and Cam shaft angle sensor
■Analysis of the waveform from the ignition coil