High Technology’s Leader!

Home > 제품소개 > PicoTechnology 오실로스코프 > PicoScope 6000 시리즈

PicoScope 6000 시리즈

PicoScope6403D

350Mhz 4채널 USB PC 오실로스코프 피코스코프

확대 이미지






       

     

     

     

     

    최고 성능, 가격대비 최고 가치 
     

    PicoScope 6000시리즈 오실로스코프는 높은 샘플 속도로 장시간 캡처를 위한 울트라 딥 메모리를 제공합니다.


    PicoScope 6000에 있는 오실로스코프와 디지타이저는 귀하에게 최고 성능, 가격대비 최고 가치를 제시합니다. 만일 귀하가 고성능 USB 오실로스코프, 또는 고속 USB 디지타이저를 필요로 한다면 PicoScope 6000 시리즈는 바로 그것입니다.

     

    PicoScope USB 디지타이저는 DC는 물론 주파수 1 GHz 까지, 샘플링 5 GS/s 까지의 전기적신호를 8비트 디지털 값으로 변환 시킵니다. 결과 값은 R&D는 물론 디버깅, 계측시험장비에 두루 쓰입니다.

     

    PicoScope USB 디지타이저는 재래식 디지타이저의 성능과 기능에 뒤지지 않으며 가격 대비 더욱 저렴하며 USB 인터훼이스 방식은 작업 공간을 적게 차지하며 전문 설비의 필요를 배제합니다.

    • 4 channels.
    • 500 MHz bandwidth.
    • 5 GS/s real–time sampling.
    • 2 GS memory!
    • Arbitrary waveform generator.
    • Serial decoding.
    • Mask limit testing.
    • USB 3.0 interface.

     


    Oscilloscope — Vertical
    모델 PicoScope 6402C PicoScope 6402D PicoScope 6403C PicoScope 6403D
    아날로그 밴드폭* (-3 dB) 250 MHz
    (200 MHz ±50 mV range)    		 350 MHz
    (250 MHz ±50 mV range)
    하드웨어 밴드폭 제한 Switchable, 20 MHz
    상승시간 (10% to 90%, calculated) 1.4 ns (50 mV range 1.8 ns) 1.0 ns (50 mV range 1.4 ns)
    수직 분해능 8 bits
    Enhanced vertical resolution 12 bits
    입력 감도 10 mV/div to 4 V/div at x1 zoom (1 MΩ input), 10 mV/div to 1 V/div at x1 zoom (50 Ω input)
    입력 범위 (풀 스케일) ±50 mV to ±20V, in 9 ranges (1 MΩ input)
    ±50 mV to ±5V, in 7 ranges (50 Ω input)
    입력 특징 1 MΩ in parallel with 15 pF (AC or DC coupling) or 50 Ω (DC coupling)
    아날로그 오프셋 범위 Available offset
    50 mV  to 200 mV ranges ±0.5 V
    500 mV range ±2.5 V
    1 V range ±2.5 V
    2 V range ±2.5 V
    5 V range ±20 V (50 Ω ±0.5 V)
    10 V range ±20 V
    20 V ±20 V
    DC 정확도 3% of full scale
    입력 타입 Single–ended, BNC connector
    과부하 보호 ±100 V to ground (1 MΩ inputs), 5.5 V RMS (50 Ω inputs)
    *Quoted bandwidth is with supplied probes or at BNC when 50 Ω impedance selected
    Dynamic performance
    노이즈 200 μV RMS (50 mV range)
    THD –55 dB typical 
    SFDR 60 dB typical
    Crosstalk 17 000:1 typical at 20 MHz
    1000:1 typical at full bandwidth
    Oscilloscope — Horizontal
    최대 샘플링 레이트 (single shot) 　
    1 채널 사용 5 GS/s
    2 채널 사용 2.5 GS/s
    3 또는 4 채널 사용 1.25 GS/s
    최대 샘플링 레이트 (반복신호) 50 GS/s
    최대 샘플링 레이트 10 MS/s using PicoScope. >150 MS/s using the supplied SDK (PC dependent)
    (continuous streaming mode)
    버퍼 사이즈 256 MS 512 MS 512 MS 1 GS
    (shared between active channels)
    버퍼 사이즈 (streaming mode) 100 MS in PicoScope software. Up to available PC memory when using SDK.
    Maximum waveforms per second 12,000 wfm/s (PC dependent)
    최대 버퍼 세그먼트 (using PicoScope 6) 10,000
    최대 버퍼 세그먼트 (using SDK) 250,000 500,000 500,000 1,000,000
    타임베이스 범위 　
    Real–time 1 ns/div to 5000 s/div
    ETS 50 ps/div to 100 ns/div
    타임베이스 정확도 ±2 ppm
    타임베이스 에이징 1 ppm per year
    Triggers
    기본 트리거 Rising, falling
    Advanced triggers Edge: single edge or dual edge; adjustable hysteresis
    Pulse width: negative or positive pulse; wider or narrower than a specified width
    Window: entering or leaving a voltage range
    Window pulse width: signal is inside or outside a voltage range for a set time
    Dropout: inactivity over a user–defined time interval
    Window dropout: signal does not enter or exit a voltage range for at least a set time
    Delay: nth event after trigger event, with optional delay
    Interval: time between two edges is greater or less than a set time, or inside/outside a time range
    Level: the signal remains on one side of a threshold voltage for a specified period of time
    Logic level: arbitrary logic state of Channels A to D and AUX
    Runt pulse: crosses one threshold but not the other
    트리거 모드 None, Single, Repeat, Auto, Rapid, ETS
    최대 트리거 레이트 Up to 10,000 waveforms in a 10 ms burst
    트리거 소스 Channels A to D, AUX
    트리거 레벨 Adjustable over whole of selected voltage range
    트리거 감도 1 LSB accuracy up to full bandwidth of scope
    Re–arm time Less than 1 µs on fastest timebase
    최대 트리거 딜레이 　
    pre–trigger capture 100% of capture duration
    post–trigger delay 4 billion samples
    트리거 타이밍 분해능 1 sample period
    Auxiliary trigger Input (AUX)
    AUX 트리거 커넥터 타입 Rear panel BNC, shared with reference clock input
    트리거 타입 Edge, pulse width, dropout, interval, logic
    입력 특징 50 Ω ±1%, DC coupled
    밴드 폭 25 MHz
    임계값 범위 ±1 V
    과전압 보호 ±5 V (DC + AC peak)
    Reference clock Input (SDK only)
    클록 입력 특성 50 Ω, BNC, ±1 V, DC coupled
    주파수 범위 5, 10, 20, 25 MHz, user-selectable
    커넥터 Rear panel BNC, shared with AUX trigger
    레벨 Adjustable threshold, ±1 V
    과전압 보호 ±5 V
    Function generator and Arbitrary Waveform Generator
    주파수 범위 DC to 20 MHz
    표준 파형 　
    모든 모델 Sine, square, triangle, DC level
    D 모델 Sine, square, triangle, DC level, ramp (up/down), sin (x)/x, Gaussian, half–sine, white noise, PRBS
    출력 주파수 정확도 Same as scope timebase accuracy
    출력 주파수 분해능 < 0.05 Hz
    DC 정확도 ±1% of full scale
    커넥터 타입 Rear panel BNC
    과전압 보호 ±5 V
    스윕 모드 Up, down, or dual, with selectable start/stop frequencies and increments
    트리거 신호 발생기 Scope, manual, or AUX input; programmable number of cycles from 1 to 1 billion
    진폭 범위 ±250 mV to ±2 V
    오프셋 조정 ±1 V (maximum combined output ±2.5 V)
    출력 임피던스 50 Ω
    AWG 버퍼 사이즈 n/a 64 kS n/a 64 kS
    AWG 샘플링 레이트 n/a 200 MS/s n/a 200 MS/s
    AWG 해상도 n/a 12 bits n/a 12 bits
    Probe Compensation Output
    출력 신호 유형 1 kHz square wave, 2 V pk–pk, 600 Ω
    Spectrum Analyzer
    주파수 범위 DC to 250 MHz DC to 350 MHz
    디스플레이 모드 Magnitude, peak hold, average
    윈도우 펑션 Rectangular, Gaussian, triangular, Blackman, Blackman–Harris, Hamming, Hann, flat–top
    FFT 포인트 수 From 128 to 1,048,576
    Software

    Windows 용 PicoScope 6    		 PicoScope 6 is your complete test and measurement lab in one application. Features include:
    Capture modes: oscilloscope, spectrum and persistence.
    Channel maths: calculate the sum, difference, product, inverse or create your own custom function using standard arithmetic, exponential and trigonometric functions.
    Mask limiting testing: pass/fail, failure count, total count.
    Serial Decoding: decode data from a serial bus such as I²C.
    Automated measurements
    Scope mode: AC RMS, true RMS, cycle time, DC average, duty cycle, falling rate, fall time, frequency, high pulse width, low pulse width, maximum, minimum, peak–to–peak, rise time and rising rate.
    Spectrum mode: frequency at peak, amplitude at peak, average amplitude at peak, total power, total harmonic distortion (THD % and THD dB), total harmonic distortion plus noise (THD+N), spurious-free dynamic range (SFDR), signal+noise+distortion to signal+noise ratio (SINAD), signal to noise ratio (SNR) and intermodulation distortion (IMD).
    Export data formats: comma separated values (CSV), tab delimited (TXT), Windows bitmap (BMP), graphics interchange format (GIF), portable network graphics (PNG), MATLAB 4 format (MAT).
    리눅스 드라이버 Linux Software & Drivers for PicoScope 6400
    소프트웨어 개발 키트 Includes drivers and example code for various programming languages including C, C#, Excel and LabVIEW.
    PC Requirements
    최소 사양 Processor: 1 GHz
    Memory: 512 MiB
    Free disk space: 32–bit: 600 MB, 64–bit: 1.5 GB
    Operating system: 32– or 64–bit edition of Microsoft Windows XP (SP3), Vista, Windows 7 or Windows 8 (not Windows RT)
    Ports: USB 2.0 compliant port
    권장 사양 Processor: 1 GHz
    Memory: 512 MiB
    Free disk space: 32–bit: 850 MB, 64–bit: 2 GB
    Operating system: 32– or 64–bit edition of Microsoft Windows XP (SP3), Vista, Windows 7 or Windows 8 (not Windows RT)
    Ports: USB 3.0 compliant port

관련상품

PicoScope6403D

PicoScope6402D

PicoScope6403D

PicoScope6403D